Photo-Tex Installation

Repositionable Vinyl Installation

 
Home
emailmailto:info@picturethispromotions.com?subject=email%20subject
We were just a little concerned how easily we could install our wall decal but after carefully reading your installation guide we were really amazed how truly easy it was. We’ve moved our decal three times witout any problem. Thanks so much. Daniel, Weston, Fl

  1. 1.Select an area large enough to display your decal. The surface must be rigid and clean. Your decal must be at room temperature prior to installing. Remove the decal from shipping container and unroll. Let stand at room temperature for 30-45 minutes.

  2. 2.Clean the area selected, using water only, to ensure no dirt or residue will adhere to the adhesive backing of your decal. DO NOT USE SOAP OR ANY HOUSEHOLD CLEANING PRODUCT. Dry the surface thoroughly with a clean cloth and let stand for approximately 30 minutes to ensure the area is completely free from any moisture.

  3. 3.The following steps are best performed by two people.

  4. 4.Once your application area is prepared simply peel the decal from the white paper backing. If your decal is taller than wider, begin at the top and peel toward the bottom. If wider than taller, peel from right to left.

  5. 5.Once your decal has been completely peeled from the backing each of the two installers should hold one of the top corners. Place the decal to the area you have selected to display it and press these corners to the wall. Do not concern yourself with the air-bubbles at this time. If the decal sticks to itself, gently pull the two areas apart and re-apply.

  6. 6.Beginning from center of the decal and using your hand, apply pressure and rub from center to outer edges to apply.

  7. 7.Roll and store white paper backing in the shipping tube for future use in the event you decide to remove and store your decal.



  1. 1.Select an area large enough to display your decal. The surface must be rigid and clean. Your decal must be at room temperature prior to installing. Remove the decal from shipping container and unroll. Let stand at room temperature for 30-45 minutes.

  2. 2.Clean the area selected, using water only, to ensure no dirt or residue will adhere to the adhesive backing of your decal. DO NOT USE SOAP OR ANY HOUSEHOLD CLEANING PRODUCT. Dry the surface thoroughly with a clean cloth and let stand for approximately 30 minutes to ensure the area is completely free from any moisture.

  3. 3.The following steps are best performed by two people.

  4. 4.Your Decal comes with either a clear or brown masking.  Once your application area is prepared simply peel the masking with decal attached from the white paper backing. If your decal is taller than wider, begin at the top and peel toward the bottom. If wider than taller, peel from right to left.

  5. 5.Once your masking and decal have been completely peeled from the backing each of the two installers should hold one of the top corners. Place the masking to the area you have selected to display it and press these corners to the wall. Beginning from center of the decal and using your hand, apply pressure and rub from center to outer edges to apply.

  6. 6.When you have pressed the decal completely to the wall, begin from the top ( or from the left, if horizontal,) to gently pull the masking from the decal.

  7. 7.As soon as you remove the top ( or left edge) place one hand on the decal and gently pull the masking.

  8. 8.As you gently peel the masking, be sure to move your hand that is pressing against the decal downward at the same pace as you are pulling the masking. 

  9. 9.Roll and store white paper backing in the shipping tube for future use in the event you decide to remove and store your decal.